Dear friends. I use CCCAMD on Dreambox usually. Cardsharing.cc suggests I use MGCAMD however I'm not sure how to install and start MGCAMD. However I'm not sure how to install mgcamd and if I need to install mgcamd-config seperately.. and such.
Is there a step by step guide to this?
Devicename: dm800se
Enigma Version: 2010-12-21-experimental
Image Version: Newnigma2 v3.2.2 2011-07-07
Frontprozessor Version: V3
Webinterface Version: 1.6.8
Tuners
Tuner A: BCM4505 (DVB-S2)
Network Interface (eth0)
Typically, there must be some option to install mgcamd manually. If not, change image (firmware). For instance, Domica supports internal downloading of any emulator (cccamd, cmd3, mgcamd, oscam, etc.). Gemini project has stopped supporting mgcamd, and we have to find other solutions. One of them is Domica image. We have info on the forum and corresponding links.
Thanks. My image has TSpanel so it wasn't hard to install it but now not sure how to configure it or check if i configured right or if its working.
Quote from: nervusvagus on 01 April 2012, 09:50:26
Thanks. My image has TSpanel so it wasn't hard to install it but now not sure how to configure it or check if i configured right or if its working.
http://www.cardsharing.cc/index.php?board=100.0