I have a Vu+ Solo and have a working setup with Mgcamd 1.35a. It has worked with every firmware I have tried, including ViX/VTi/Blackhole 1.72 and 1.6.6... I im sure its pretty universal.
Just add your own CWS = line to 'newcamd.list' and reboot, it should come straight on.
Better to remove everything you've tried and start again, just to be sure.
----
First make sure CCcam is disabled and remove any mgcamd plugins already installed.
1. Download the file
attached to this post, or the same file from here...
http://www.4shared.com/zip/7I1rgVRG/vu-plus-mgcamd-CardsharingServ.html2. Extract it somewhere. There are 2 folders in it. "tmp" and "keys".
3. Copy "enigma2-plugin-cams-mgcamd.1.35a_1.0-r3_mipsel.ipk" from the "tmp" folder to the "/tmp" folder on your receiver via FTP.
4. Edit the 'newcamd.list' file with notepad or something similar from the "keys" folder just extracterd and replace the CWS line with the one from your account here.
5. Copy all the files from that "keys" folder to "/usr/keys" on your receiver via FTP.
6. Install the "enigma2-plugin-cams-mgcamd.1.35a_1.0-r3_mipsel.ipk" file on your receiver via the install local extensions option.
7. Reboot the receiver.
8. Go to a normally encrypted channel. Press the blue button and go to the softcam manager.
9. Enable the Mgcamd 1.35a plugin. And, press the coloured button to enable it to load automatically on startup.
done!
------
Hope that helps anyone having problems with any Enigma2 based receiver. My mg_cfg file has the receiver set to "00" it should autodetect Enigma2 just fine. But you could put "06" there too.