Вход в биллинг - Billing entrance - www.CardsharingServer.com

English forum section

Автор Тема: Oscam configure  (Прочитано 6620 раз)

Grisha1

  • Пользователь
  • **
  • Сообщений: 35
Oscam configure
« : 04 Ноября 2015, 20:35:24 »
Hello

 I would like to use oscam for my VIP ALL,
I have copied data from my account to
oscam.server but it's not clearing the channels.
ma be something must be changed
in another files oscam.cfg, dvbapi...
your help is highly appreciated.
Openbox SX4, newcamd, wicardd, Vip All, Grisha 1

Jogi

  • Старожил
  • ****
  • Сообщений: 445
Re: Oscam configure
« Ответ #1 : 05 Ноября 2015, 12:21:49 »
perhaps take a look at http://www.streamboard.tv/wiki/OSCam (website is not always available, but yet it can be accessed)
there you will find example configuration (in this case "Sky Germany HD and MTV-Unlimited", scroll down to "Client connection with Oscam DVB API" section)
and you can also see all additional oscam-files for configuration available, what parameters can be used and some examples

really necessary are only oscam.conf, oscam.user and oscam.server - try to use only this files to get it work, the other files are only for optimization. But with correct configuration these 3 files will get the channels decoded, than you can go on with additional settings.
And if you check the configuration files like oscam.conf, oscam.server etc: start to use parameters marked as required and perhaps add some optional parameters if it already works.

BTW: why do you want to use Oscam ? I use Oscam because I have local smartcards in my receiver, which cannot be used with Mgcamd but without own smartcards in your local reader there is no advantage in Oscam

it might be easier to configure using the web-interface of oscam (which is optional *g*), so perhaps take a look at oscam.conf for webif-settings: http://www.streamboard.tv/wiki/OSCam/en/Config/oscam.conf#WebIf (english version).
Once you have defined [webif]-section in oscam.conf and restarted Oscam you can access your Oscam website via http://<ip-of-your-receiver>:<defined httpport>
AX-HD51 STB using NeutrinoHD and Oscam with VIP-Astra. Dual login on server_81 via Cable-ISP

Grisha1

  • Пользователь
  • **
  • Сообщений: 35
Re: Oscam configure
« Ответ #2 : 05 Ноября 2015, 21:02:41 »
Thanks a lot Jogi for your explanation

 This is the point, I have local cards.
Just short expl.
 We are seaman and use this server cs on board of our ship,
internet we have only when we are in port or near the coast, using mobile 3G internet.
We purchased few prepaid cards to use when we are at sea (no internet)
that is the point I would like to use Oscam.
 Of coarse it's possible to switch emus from mgcamd cs to
Oscam for local cards when it's necessary, but I try
to configure Oscam for both purposes.
 Actually what I looking for to set Oscam for Hotbird 13, Sky Italia, nc+, ...
Our motorized, gyro synchronyzed antenna (marine version)
is set to this satellite.
 On the example of any two packages, possible to configure as it's require.
Many thanks
Openbox SX4, newcamd, wicardd, Vip All, Grisha 1