How about posting a log? I doubt anybodies but the admins crystal ball is good enough to figure out whats happening on your end without it.
From your screenshot it looks like you are
- not connected to the server, which would explain why nothing gets decoded
- on the other hand you did send requests to the server in the past, from which some where successfully decoded
- some where rejected/filtered, which usually means you send a request to the server for a srvid the server doesn't decode, for whatever reason (e.g. not a part of your subscription or simply not found)
The EMM requests are most likely caused by OSCam using CCcam (since the number of requests matches the number of connection)
From my experience a CCcam reader in OSCam will send a single EMM request to the server per reader start/restart, regardless of AU being disabled or not (on the reader/dvbapi/user/whatever)
Simply use newcamd instead of CCcam to get around this, this also allows you to get a more fine grained configuration (one reader per sub/CAID, proper fallback per group and so on) and you can still use EMM on your local readers.
There is also no point sending keep alive requests to the server.
The moment you have something to decode the reader will send the request and, if necessary, connect to the server.
Lastly i do hope you are not using multiple emus/protocols at the same time as the screenshot implies, as you don't gain anything from it.
Pick one emulator/protocol (e.g. oscam w/ newcamd) and stick with it.
Cheers