Tecview 2050 FAE receiver has built-in sharing option.
Sharing is provided by manufacturer (at the moment- more than 100 channels).
When you turn on your receiver, the connection to server is automatic. Using EMU it is possible to open all possible encrypted channels.
The receiver operates in 3 modes:
1.S/W Update----connection to the manufacturer's server.
2.P2P--------using this mode it will be possible to connect several receivers between themselves.
3.Dream Net-------In this mode the receiver operates using Radegast and NewCamd protocols.
In order to enable the receiver operating in all three modes, you need the latest software pimg_2050fae_eu_v_test_newcamd (It's a test version, there is no final version yet.
It can be noted from the testings, that this software is not so good for each of the servers. Of FIVE servers tested only TWO are running good).
So, download the software from Zotos (the link is provided).
In order to run Dream Net mode the following is required:
Menu.>>>System settings>>>Network>>>Service Setup>>> enable Dream Net. Press Connect (Green button). A window will appear in which you will be asked, whether you like to select the mode. Press red button. Your receiver will restart. Then select CS in menu.
1.You must have Dream Net enabled.
2.SoftCam-----NewCamd.
3.Auto Connecnion---This mode does not work yet. It will be modified in the next version of the software.
4.Server No-------Currently you may set up 3 servers. In the future it will be possible to set up 4 servers. Select 1.
5.Card Type-----Set up the card type.
6.Server Connecnion-----Using Domain or Using IP.
7.Server"s Domain-----Server address or server IP.
8.Server"s Port---------Set up port.
When you perform all these settings, finally, press Сonnect (green button), a window will appear where you should set up your details received from Moderator:
1.Login-----your login XXXXXXXXXXXXXX
2.Password---your password. XXXXXXXXXXXXXXXX
3.DesKey---------XXXXXXXXXXXXXXXXXXXXXXXXXX
4.Server name-------If any. If no name, nothing is required. XXXXXXXXXXXXXXX
As soon as you type all the details correctly, press OK, i.e. red button.
A picture will appear after a couple of seconds.
Note, that all settings should be made when you select the channel required for sharing.
There is one inconvenience- no possibility to set several ports at a time.
That's all. Enjoy viewing!